Submitting an SF-86 Online:
Access, Saving, Signing, and Release Forms
SF-86 online in eApp: how access starts, saving, certification vs releases, Click to Sign, sponsor review and what to keep after Submit.
Updated October 26, 2026
Security Clearance
Filling out the SF-86 online means working inside eApp, the questionnaire system run by the Defense Counterintelligence and Security Agency (DCSA), and a sponsor starts the request before you see a single question. DCSA describes your part in one sentence: complete an electronic questionnaire, sign a certification of the information you provided, and sign releases.
Most mistakes happen after the last section shows complete. Certification, the release screens, the lock on Submit and the sponsor’s review each have their own rules, and each one is a separate handoff.
1. The Subject eApp Guide says to set time aside because the form can take several hours; the average is 150 minutes including document gathering, and the invitation can expire.
2. A green dot means a section is complete. The final screen still says “Not a guarantee of acceptance.”
3. The certification and each release are signed one by one. The app will not submit until the certification, the general release and the credit release are signed; the medical release, when it appears, can be skipped after a warning.
4. Submit locks the form and sends it to your sponsor, not straight to an investigator.
5. Save the PDF before you leave the screen, and record who your sponsor contact is.
How do you get access to the SF-86 online?
A sponsor creates the investigation request, and eApp access follows from it. For a cleared-contractor candidate, a Facility Security Officer (FSO) starts the request; for federal applicants, the sponsoring agency asks you to complete the questionnaire. Questions about the form go to that same sponsor: the FSO for a contractor, the security officer or HR office for a federal applicant.
On the industrial side, DCSA’s page for processing applicants says the FSO or a designee initiates the eApp in the Defense Information System for Security (DISS). The security management office then receives a DISS notification with eApp account instructions and a Personal Identification Number (PIN), also called a Registration Code, and the FSO passes both to you.
DCSA’s e-QIP page says agencies can grant applicants access to e-QIP to save copies of old SF-86 forms, and it splits the contact for lockouts and resets by applicant type. Federal, military and DoD employees or applicants, and non-DoD federal contractors, go first to their sponsoring or employing agency. Industry (DoD contractor) applicants are pointed to the DCSA Applicant Knowledge Center for lockouts, challenge question resets and PIN resets. DCSA’s forms page sends contractors with questions about completing the questionnaire to the FSO at their company. If you are still looking for the old e-QIP application, the comparison in e-QIP versus eApp explains what changed.
The Subject eApp Guide (version V2, dated November 29, 2023) adds two practical points. The sponsor may set how long you have, and you should begin as soon as possible so the invitation does not expire.
How do you save progress and clear every section error?
Use the section menu on the left, not the browser’s Back button, and watch the save indicator. A section turns green when it is complete. The review page for each section lists errors in a red box, and you can fix them or leave them and return, but none may remain at submission.
The eApp interface carries a “Save now” control and reports “Saving” and “Saved” as it works, plus an error message (“There was a problem saving your data, please try again.”) if a save fails. Treat that message as a stop sign and click Save now again before you move on. If you step away, a prompt asks “Are you still working?” and logs you out after a countdown of seconds unless you answer.
Open the form in one tab only. The system warns “You already have a session open in this browser” if you refresh the page or open a second tab or window, and tells you to close the extra tab and continue the current session.
The eApp help page explains the color code. A solid green dot appears beside each section and subsection that is complete. No dot means the section needs more information or has errors. You can edit answers as often as you like before final submission, and only your final answers are submitted. Warnings and red marks can be skipped while you work, but all errors must be addressed before you submit.
What should the final review catch before you certify?
Check dates and contact details yourself. The system’s automatic check is described as “preliminary validation,” and its completion banner says it is “Not a guarantee of acceptance.” The banner speaks of required fields being complete; nothing in it says your dates are compared with your records.
The Subject eApp Guide gives helpful tips and section notes on dates, addresses, employment entries and verifiers. Use them as your read-through list.
| Check | What the eApp Guide says |
|---|---|
| Date gaps | No gaps in dates. Time off before a new job is listed as unemployment, and dates use mm/dd/yyyy. |
| Unemployment | Unemployment and employment dates cannot overlap, and you are still unemployed if you receive no benefits. |
| Addresses | Complete physical addresses, no PO boxes. Remote workers list a home address as the work location. |
| Address verifiers | A verifier for every address in the last three years, someone who has been to the residence. Relatives you must already list and cohabitants do not qualify; in the guide, a cohabitant is a partner you are not married to, not a roommate. DCSA’s November 2025 guide names neighbors, roommates and landlords as the best verifiers and says not to list yourself, your spouse or your children. |
| Same employer, two sites | Separate employment entries for each physical location. |
| Vague answers | Avoid “I do not know,” “Unknown,” or “Not Applicable.” |
| Lookback | Most sections run back 10 years, and nothing before your 18th birthday unless two years of history are needed. DCSA’s November 2025 guide gives seven years for foreign contacts, foreign travel and drug use, and asks about foreign financial interests with no time limit. |
Some questions reach back further than 10 years and others stop at seven, so read each prompt’s own window. DCSA also warns that leaving out requested information could affect your eligibility for the position or for access to classified information. The practical effect of gaps is covered in how missing SF-86 information affects eligibility.
What is the difference between certification and the releases?
Certification is your statement that the answers are true. A release is your permission for others to gather or disclose information about you. eApp lists them as separate items to sign: Certification, Release of Information and HIPAA, and Credit reporting disclosure. The app says you will not be able to submit until each release below is signed; the medical release is the exception, covered below.
| Item | What you are signing | Detail from the form text |
|---|---|---|
| Certification | That your statements are true, complete and correct to the best of your knowledge and belief and made in good faith, and that, to the best of your knowledge, you have not included classified information in the form | It cites 18 U.S.C. 1001 for a knowing and willful false statement and warns that withholding, misrepresenting, falsifying or including classified information can affect your clearance and job, up to removal and debarment from federal service |
| General release | Permission for the investigating agency to obtain information from schools, employers, criminal justice agencies, credit bureaus and other sources | Photocopies are valid, and it stays in effect while you hold a national security sensitive position or need eligibility for access to classified information |
| Credit reporting disclosure | Permission to request consumer reports under the Fair Credit Reporting Act | Carries a note about security freezes, covered below |
| Medical release (HIPAA) | Permission for the investigator to question your health practitioner about mental health consultations | Printed for a Yes at Section 21; valid for one (1) year from signing or until your affiliation with the Federal Government ends, whichever is sooner; revocable by writing to your provider |
The general release adds that separate, specific releases may be needed for financial institutions, medical institutions and other sources, and that you may be contacted for them later. Signing the screens does not end your paperwork.
The medical release is the one the app handles differently. If you reach Submit with it unsigned, the app tells you that you are not required to sign it to submit, but that continuing without signing “may have an impact on your investigation.” The Subject eApp Guide is firmer: it says any Yes answers to the mental health questions require the Authorization for Release of Medical Information signature form. The SF-86 prints the release for people who answered Yes at Section 21, so ask your sponsor whether it applies to you before you skip it.
The credit screen has a trap. The 2016 edition of the SF-86 posted by OPM tells you to respond to requests to release a credit freeze. OPM’s Suitability Executive Agent Notice 24-01, written for agencies and dated January 8, 2024, reminds them that individuals undergoing background investigations do not need to lift freezes, and eApp displays a banner telling you to disregard the lift-the-freeze instructions. When the paper wording and the screen disagree, follow your sponsor’s instruction.
How does Click-to-Sign work?
Click to Sign is eApp’s electronic signature. Each signing screen asks you to verify your full name, other names used, date of birth, Social Security Number, current address and telephone number, then to type your name to sign. Read the text above each signature box, because it is what you are agreeing to.
DCSA says the applicant digitally signs the certification and release forms through the Click to Sign (C2S) feature. For industrial applicants, the FSO can then open a Documents link that shows every electronically signed signature and release page.
DCSA says that if the applicant opts out of C2S, the FSO should verify that the submitted signature pages were generated by eApp with the specific request number, and scanned pages go to DCSA through Safe Access File Exchange (SAFE). If your company asks for paper pages, take the exact steps from the FSO. The instructions on the paper SF-86 itself say to sign and date in ink and to retain a copy of the completed form.
Where does the questionnaire go after you submit?
It goes to your sponsor for review. Before the click, eApp asks you to confirm and warns that once you submit, your form will be locked and you will no longer be able to make changes. It also records the certification time in Coordinated Universal Time (UTC), whatever your own time zone.
| Stage | Who acts | What the sources say |
|---|---|---|
| You submit | You | The form locks, and the signed pages can be downloaded afterward |
| Sponsor review | Sponsoring agency, or the FSO for industrial applicants | The agency checks accuracy and completeness; the FSO reviews the package for completeness |
| Release onward | FSO | After all pages are signed, the FSO releases the eApp to Trust Decision (Adjudications) for review |
| Investigator’s check | Investigation Service Provider | Reviews the package for completeness before opening the investigation |
DCSA’s guidance for FSOs adds that an incomplete package is worked out between the provider, DCSA and the FSO, and a request that cannot be fixed ends as “Terminated by ISP.” The same page says fingerprints for initial investigations are sent electronically after the eApp is released, so expect that as a separate step. For a wider view of the agency doing this work, read what DCSA does.
What does a returned questionnaire look like?
A returned form is a correction request. DCSA says the sponsoring agency may send the questionnaire back to you to correct errors or missing information. The same page adds that the agency can begin judging suitability and can make an unfavorable determination at any point in the investigation, so answer a correction request promptly and accurately.
Inside eApp, the returned form opens with a banner: “Your application needs further edits after review by your agency representative. Please address their comments found in the email provided.” The banner adds that some yes-or-no questions have been cleared, and asks for your most current answers.
So read the reviewer’s email first, start with what it names, and re-answer every cleared yes-or-no question as of today, not as of your first session. Then run the review pages again before you resubmit.
How do you keep a record without storing data carelessly?
Save the PDF at the moment the app offers it, and keep it somewhere controlled. The help page warns that you will not have another chance once you leave the form. The app’s later “Download your documents” page offers an archival copy only until a stated date, and its error message says one archival download is allowed per session.
That file holds your Social Security Number, your relatives’ details and your references. Keep it on an encrypted drive you control, not in an email thread, a shared folder or a notes app. Send it to no one unless your sponsor asks.
The record that matters for follow-up is small: the date and time shown on the confirmation (in UTC), the name and email of your sponsor contact, and the request number if one was shown.
What is the final-session checklist?
- Set aside several hours (the guide’s average is 150 minutes, gathering included), and keep a single tab open.
- Open the section menu and confirm every section has its green dot.
- Open each section review page and clear the red box.
- Re-read dates, addresses and contacts against your own records.
- Verify the name, date of birth and address on each signing screen, then sign the certification and each release.
- Decide, with your sponsor, about the medical release before you reach the warning.
- Submit, then save the PDF before you close the page.
Before you click Submit, write down the name and email of your sponsor contact, because every handoff after that click runs through that person.
Frequently Asked Questions
Can I start the SF-86 online without an invitation?
The DCSA pages describe access as starting with the sponsor. Industrial applicants receive account instructions and a Registration Code from the FSO, and federal applicants are told by their sponsoring agency to complete the questionnaire. If you have no invitation, ask your sponsor or employer’s security office.
Does eApp save my answers if I close the tab?
Do not count on it. Click Save now before you leave and wait for the Saved message; the interface also shows how long ago the last save happened. Use the section menu to move around instead of the Back button.
Do I have to sign the medical release?
eApp allows you to submit without it and warns that doing so may have an impact on your investigation. The Subject eApp Guide says any Yes answer to the mental health questions requires the form. Ask your sponsor before you skip it.
Can I change an answer after I submit?
Not on your own. eApp says the form is locked after submission. If the sponsor finds errors, it may send the questionnaire back to you to correct, and then you can edit again.
Do I need to lift a credit freeze?
OPM’s 2024 notice and eApp’s own banner say you do not need to lift a freeze for a background investigation. Older form text still says otherwise, so confirm with your sponsor if anyone asks you to.